Icom IC-A21 - Revision history

Elijah at 01:20, 10 March 2024

2024-03-10T01:20:04Z

← Older revision		Revision as of 01:20, 10 March 2024
Line 1:		Line 1:
			[[Category: Ham Radio]]
			I used one of these in my DIY "ASOS" system, to detect mic "clicks".
	== Squelch circuit ==		== Squelch circuit ==
	Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch control pot and is rectified to a DC voltage. When high enough, this voltage turns on Q1008 pulling its output low. For an active high signal monitor the output of inverter Q1009. This signal goes across the ribbon cable to the logic board and is called 'sql'.		Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch control pot and is rectified to a DC voltage. When high enough, this voltage turns on Q1008 pulling its output low. For an active high signal monitor the output of inverter Q1009. This signal goes across the ribbon cable to the logic board and is called 'sql'.

Elijah at 06:14, 27 August 2018

2018-08-27T06:14:11Z

← Older revision		Revision as of 06:14, 27 August 2018
Line 3:		Line 3:
	== Squelch circuit ==		== Squelch circuit ==
	Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch control pot and is rectified to a DC voltage. When high enough, this voltage turns on Q1008 pulling its output low. For an active high signal monitor the output of inverter Q1009. This signal goes across the ribbon cable to the logic board and is called 'sql'.		Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch control pot and is rectified to a DC voltage. When high enough, this voltage turns on Q1008 pulling its output low. For an active high signal monitor the output of inverter Q1009. This signal goes across the ribbon cable to the logic board and is called 'sql'.


			{{pdf\|Icom_ic-a21_service_manual.pdf\|Service manual}}

Elijah: Created page with " == Squelch circuit == Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch..."

2016-05-23T00:19:01Z

Created page with " == Squelch circuit == Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch..."

New page

== Squelch circuit ==
Noise components of the signal are output from IC1004 on pin 9. This is marked IC4 on the board and is an MC3372P. This then goes through the squelch control pot and is rectified to a DC voltage. When high enough, this voltage turns on Q1008 pulling its output low. For an active high signal monitor the output of inverter Q1009. This signal goes across the ribbon cable to the logic board and is called 'sql'.