Elijah at 07:45, 28 February 2024

2024-02-28T07:45:32Z

@@ Line 4: / Line 4: @@
 ==Data Logging==
-While not strictly necessary, this is a quick and fun little project that gives you some insight into how much battery capacity is being used. I have the following setup:
+While not strictly necessary, this is a quick and fun little project that gives you some insight into how much battery capacity is being used. First, you need to get the data off the charge controller via modbus. Morningstar sells some serial to modbus adapters, I got the one that has RS-232 on one side and an RJ-11 to plug into the charge controller's modbus on the other. I'm using a raspberry pi which was already being used as an OGN (open glider network) receiver. A USB->Serial adapter plugs into the pi and that plugs into the modbus adapter. Then, I run the following little program to dump the data out of the charge controller and put it into an rrdtool databse:
-https://gist.github.com/AD7ZJ/525e2973fee1669ceeba2ad0223c2f78
+rrdtool database, create as follows:

Elijah: Created page with "Sometimes you just need a small solar system to power some lights, radios, or a raspberry pi. This, is that! I have setup several of these at our glider field to power securit..."

2024-02-26T23:27:01Z

Created page with "Sometimes you just need a small solar system to power some lights, radios, or a raspberry pi. This, is that! I have setup several of these at our glider field to power securit..."

New page

Sometimes you just need a small solar system to power some lights, radios, or a raspberry pi. This, is that! I have setup several of these at our glider field to power security cameras, radios, charge batteries, etc. It always goes like this: Solar panel -> charge controller -> battery.

I have used morningstar charge controllers for all the systems. We tried some off-brand ones and while they worked ok, they did not reliably disconnect the load at low voltage. That kills your batteries and there goes your cost savings! I like the morningstar SS-MPPT-15 controller. Since they are MPPT you can use them with the large, higher voltage panels cheaply available these days. I can typically get panels 250-300w output for around $100.

==Data Logging==
While not strictly necessary, this is a quick and fun little project that gives you some insight into how much battery capacity is being used. I have the following setup:

https://gist.github.com/AD7ZJ/525e2973fee1669ceeba2ad0223c2f78

Small solar systems - Revision history

Elijah at 07:45, 28 February 2024

Elijah: Created page with "Sometimes you just need a small solar system to power some lights, radios, or a raspberry pi. This, is that! I have setup several of these at our glider field to power securit..."